Connecting the T2 API Laser Tracker
How to connect the T2 API Laser Tracker.
Need proper files installed.
Locate the USB thumb drive that is included with the tracker. (This holds the prm file)
Place the prm file in C:\program files (X86)\verisurf device interface
then once placed, download and install the t2cal software. 2cal_v1.2.2.1.Exe
once installed, ensure that the tracker is communicating in the t2cal software. (If not communicating, ensure that all hardware is connected properly)
If communicating in t2cal, proceed to download and install the API t2 t3 tracker support. Api_t2_t3_tracker_support_6_21_2007.Exe (This will configure the device and vdi)
Once completed, you will be able to start the device in verisurf without any further errors.
If additional assistance is still required after performing these steps, please call Verisurf Support at 1-888-713-7201
Related Articles
Looping Laser Tracker Survey or Drift Check Test in Auto Inspect With Timer Delay
Case: How can I run a survey or drift check through Automate? Cause: This cover the basics in setting up a Timer Delayed looping survey for checking SMR locations using a laser tracker. Solution: The first step would be to measure or enter each ...
How to register the SwDocumentMgr.dll file?
Case: Cannot find Parasolid data in SoldiWorks file error when trying to open it. The SwDocumentMgr.dll file must be manually registered. Cause: The SwDocumentMgr.dll file did not register correctly and must be manually registered. Solution: There ...
Leica Absolute family of Laser Trackers and Measurement Parameters and Modes
Case: The sample rate is slow when measuring using Stationary Points. Similar Case: How is the measurement rate increased? The DRO seems to be lagging. Description: We often get asked about the sample rate, measurement parameters, and modes for the ...
The what, when, how, and why with Closed Face Reflector and Enabling a Vector Offset in Verisurf for Laser Trackers
Case: The what, when, how, and why with Closed Face Reflectors and Enabling a Vector Offset in Verisurf for Laser Trackers What: Closed Face Reflectors cause refraction (deflection) when passing through the Face of the Reflector, resulting in the ...
Cylinder Position Calculation
Case: How is position calculated on a cylinder? Similar Case: The cylinder is being moved upon completion in Automate/Auto Inspect. The cylinder is being moved when adding it to the Report Manager. Description: In Report Manager, whether the Cylinder ...